Making a Component Movable

To be able to transfer a component from one unit to another, you must add the component to one of your Movable component categories.

Note: Setting a component as movable is only possible at the office installation of TM Master V2.

1. Start and log on to TM Master V2 at the office using an account with the correct user rights (ref chapter movable user rights).
2. Click Inventory | Components.
3. Double click the component you wish to turn into a Movable component.
4. Click the “Specification” main tab.
5. Click the “Movable Component” sub-tab, found in the bottom of the “specification” form. (ref image)
6. Tick the “Movable asset” check box.
7. Select the “movable component category” for this component.
8. Click Save.
9. If the component, you configured as movable has any subcomponents you will be asked to confirm that they too should be made movable. All subcomponents of the component will be set as “movable”.

This is the “Movable Asset” tab found on the Component specification form.